INDIVIDUAL CLOSED LOCKER BASES

 

Front and End bases are designed to fit between standard LockersMFG 6” legs. They present a clean flush appearance and prevent the accumulation of dust and dirt under the lockers. (Not for use on All-Welded lockers). Front base snaps in. also, End base slips over legs during locker assembly.

 

Closed Bases are available in the following widths and heights:
9×6, 12×6, 15×6, 18×6 and 24×6.

End Bases single row is available in the following depths and heights:
12×6, 15×6, 18×6, 21×6 and 24×6.

End Bases Double Row are available in the following depths and heights:
24×6, 30×6 and 36×6

Zee Bases

ZEE BASES

Zee bases raise lockers without 4” legs off the floor when there is no concrete or wood base. They provide a toe space in the front and a concealed flange for floor anchoring at the rear. A special 4” high rear leg can be ordered to simplify installation. Also available for 6” high zee bases.

Zee bases are available only in 72” lengths and may need to be cut to fit at the time of installation. Splices/End Locker Bases complete end of rows, and where the front sections join. (Not for use on All Welded Plus Series.)

Likewise, front zee base is available in 72×4.

 

Splice/End Base Single Row is available in the following depths and heights:

12×4, 25×4, 18×4, 21×4 and 24×4.

 

Splice/End Base Double Row is available in the following depths and heights:

30×4, 24×4 and 36×4.

 

Zee Base Filler is available in a 4” height.

Rear leg for Zee is available in a 4” height.

Fillers

wall-angle-filler-skematic wall-angle-filler-options

FILLERS

LockersMFG provides standard fillers to adapt lockers to a wide range of field conditions and provide a professional, finished appearance. Also, fillers can be used to cover columns, pipes or other obstacles in a row of lockers, or fill the gap between the lockers and a wall.

 

Vertical Fillers

 

These Come in two widths and finish Wall Angle Slip Joints for a stable fit and smooth finish. Notably, the slip-joint conceals any raw edges caused by field cutting.

 

Top Fillers

 

Top Fillers cover gaps between tops of lockers. They overlap the locker tops and can be field cut to allow for pipes, etc. There are separate designs for flat top vs. slope top, and in-line vs. corner applications.

 

Vertical Angle Fillers are available in the following widths and heights:

5×60, 5×72, 9×60, 9×72, 9×78, 12×60, 12×72 and 12×78.

 

Wall Angle Slip Joints are available in the following heights:

60, 72 and 78.

 

Flat Top Fillers are available in the following widths and depths:

15×12, 15×15 and 15×18.

 

Slope Top Fillers are available in the following widths and depths:

15×12, 15×15 and 15×18.

 

Flat Top Corner Fillers are available in the following widths and depths:

12×12, 15×15 and 18×18.

Slope Top Corner Fillers are available in the following widths and depths:

15×12, 15×15 and 15×18.